ELECTRICITY SAVER NITRO

Nitro fuel contains castor oil, synthetic oil, or a mixture of both that possible to reduce friction and helps the RC engine run cooler. Synthetic oil lubricates well at low temperatures but at high temperatures it burns off and provides little protection. While castor oil breaks down at high temperatures that creates a lubricating film. Nitro fuel for cars usually uses castor oil or, more commonly these days, a castor oil / synthetic oil mix. RC aircraft fuel typically uses synthetic oil but may also use a castor oil / mix synthetic oil.

The amount of oil found in nitro fuel is between 8% to 25% of the range with 15%-20% being the typical amount of oil found in nitro fuel. There is some debate as to whether an RC aircraft that often runs at wide open throttle during most of its run needs a higher percentage of oil than an RC car that only runs at full throttle for short spurts. An RC car or truck with a hopped-up engine that does a lot of high speed racing may need a higher oil percentage than one running a stock engine and not involved in professional racing.

Other Types of RC Fuel

While 10% to 40% is the typical percentage of nitro in nitro fuel, you can buy fuel with as much as 60% nitro or with 0% nitro (FAI fuel). Most RC cars and trucks use 10%-40% nitro blends. RC airplanes may use lower nitro blends of 5%-10% nitro. There are also RC engines that run on regular gasoline mixed with motor oil or diesel fuel (these are engines with spark plugs rather than glow plugs) as well as jet-turbine engines that use propane or kerosene. These are specialty radio controlled models and not the kind most often sold in hobby shops.

Best Fuel for an RC Nitro Engine

It is generally best to start out with the type of fuel recommended by the manufacturer for your RC engine - and the recommended engine settings -- whether that glow engine is in a car, truck, airplane, helicopter, or boat. Once you become more familiar with your RC and understand how the various nitro blends affect performance you can start experimenting to find the nitro/oil mix that works best for the way you use your R

The increase in the fuel cause many negative impacts in the community. It has been predicted by the executive, but there is a positive side of this increase of the electrical energy needs in the community by using the nuclear reactor.

Nuclear Energy was confronted by many advanced countries such as USA, UK, Germany, etc., but as long as its utility on the community advantage then this is highly boosted. One of them is the development of nuclear reactor to meet the needs of electricity; the government has begun to realize its plan especially in Indonesia.

In the world at this time there are 441 nuclear reactors. In fact, until the year 2020 State Electricity will be 126 units. From that amount, 40 of them are in China. China State Electricity has been determined utilizing a cheap, safe and clean to meet the needs of 1.3 billion people. In other countries, France meets 78 percent of the electricity needs of State Electricity. Japan also, about 40 percent of electricity needs from State Electricity that has been gained from State Electricity. Recently, U.S. President George W Bush has delivered the planned construction of the U.S. nuclear energy by 2010, and reminded about the dangers of dependence on oil. Giving an example France, China and India, President Bush urged the program 1.1 billion U.S. dollars to promote the construction of nuclear power energy, something the U.S. has not done since 1970s.

In fact, in the U.S., 2002 U.S. president George Bush has launched Nuclear Power 2010 program with a focus on the commercialization of generation III + reactor. This program is supported by the U.S. Energy Policy Act 2005 (Epact 2005). Based on this Law on the Government to provide three forms of U.S. subsidy for the nuclear industry: production tax credit equal to 18 U.S. dollars / MWh to 125 million U.S. dollars per 1,000 MW, provisions for the insurance up to 80 percent of project cost and the federal government and risk insurance of 500 million U.S. dollars for the first two units and 250 million U.S. dollars for units 3-6. This guarantee will be paid if the delay was not caused by the recipient of the license. Many of these subsidies create economic PLTN better because a number of risks and investment costs borne by U.S. consumers and the public.

Russia and some other western European countries are countries that have used nuclear energy in electricity needs, both settlements and industry. Chernobyl tragedy and the case of radioactive waste spillage should not negate the main reason for the development of nuclear energy in Indonesia. Resources to support the construction, technology, processing uranium as a raw material for nuclear energy, radioactive waste and the processing that must be optimized.

People are always eager to find new ways to save money and in crease profits.
With many companies striving to remain profitable in an increasingly competitive global market and with a new international focus on the need for energy conservation, imagine the savings and business opportunities available to you with this new invention that is proven to save upto 35% in electricity costs.

HOW IT WORKS
POWER savers use a state of the art electrical technology to actively monitor and improve the power factor of your household / office appliances, in addition, the intelligent technology optimizes the voltage and current demands thus reducing the active power / KwH demands and achieves upto 35% savings on your electricity bill, it also acts as a voltage stabilizer by storing energy for up to 10 seconds and therefore supplies the load with constant voltage during momentary power surges, this in turn results to longer lifespan of the electrical appliances.
Principle: power compensation is the basic principle of a capacitive load of power and emotional power load devices and connectivity of the line, when the capacitive load the release of energy, the emotional load of energy absorption and the release of emotional energy load, but capacitive load In the energy absorption, the energy exchange between the two load, so absorbed by the emotional load of the power output by capacitive load of power in compensation, which is the principle of power compensation. Compensation is the spot for electrical line terminal (gas) for the compensation, with electrical appliances installed in the vicinity of a small investment, small size, ease of installation and effective compensation for energy saving has extremely important practical value.
Effects: in situ current balance, improve the quality of voltage lines end. Improve the power factor, the full use of energy, reduce line losses.

VERSATILE FOR USE. IN
Shops, homes, restaurants, offices, factories (single phase), etc.

TECHNICAL PARAMETERS
Rate Voltage: 110-250VAC, 50HZ / 60HZ
Working Temperature: -15 degree to 60 degree
Single phase model
Use one POWER Saver for every 18,000 watts

INSTALLATION PROCEDURE
- Plug this device into a wall socket, not an extension cord or multiple socket and switch on the unit.
- When you see 2 green LED lights turn on, the unit has started saving electricity
- Install one power saver to each phase.

PRECAUTIONS
- The device must be plugged in firmly. Avoid loose connections.
- This device can store electrical charge, wait for 10 seconds after the electrical supply is switched off before unplugging the device.
- Keep away from children.
- Do not tamper, open or repair the POWER Saver by yourself, call your dealer or distributor for service.

Nitromethane is a simple of Nitro organic complex. This substance is rarely applied for public purposes because the energy stored in it is very huge, and even exceed the explosive TNT, so it is wondering caused greater damage. This substances is a little thick, which is used as a solvent in various applications such as in the industry device and reactive substances for cleaning solution. As a reactant in organic synthesis, widely used in the manufacture of pharmaceuticals, pesticides, explosives, fibers, and coatings. It is widely use of fuel in the race.


Nitromethane is not recognize as explosive substances since 1950s, although the explosion happened on the train which burned its tankage with leaving a big hole. Some researches are done that nitromethane is more vigorous than the explosive TNT. Pure nitromethane is immune to the explosive, but even so inhibitors may be used to reduce the danger.


Nitromethane is used as a fuel in racing, particularly drag racing, to provide more energy. Nitromethane is usually used as the fuel mixture. This is because nitromethane can provide power even in the lack of atmospheric oxygen, as described above, but also because of nitromethane tends to produce energy since the pre-ignition. A rich mixture that will cause problems given ignition and combustion speed lower. In this context, it is commonly referred to as a "Nitro" or "fuel". He has also been used as model rocket fuel. This is usually mixed with Methanol.

Indeed, save the use of electricity household is not difficult to be implemented. It is required only the attitudes and behavior of sparingly electricity in the family member, including as follows:

1. Use of electric power that are connected in accordance with the needs of electricity day-to-day.

2. Use household equipments, especially electronic equipment appropriately and it is needed.

3. Create the habits that electricity sparingly as a daily behavior in all family members, such as:

· Turning on the electricity equipment at the time used.

· Use electrical equipments alternately which means never turn on some equipment at the same time.

· If possible, use electricity to increase family income (activities that are productive).

Tips to save electricity Lights:

· Use saving energy lights that affordable quality.

· Make a habit to turn off lighting when it is not in used.

· Use electronic Ballast and install condenser TL lamps (neon) for your comfortable

· Lights on the terrace lamp at the time of the night come and immediately
light off when the sun began to rise.

Tips to save refrigerator or freezer

· Choose a refrigerator with the size and capacity that relevant with your house power

· Make sure the refrigerator door is always closed

· Do not fill the refrigerator or freezer with over capacity,

· Avoid putting the hot food / drink into your refrigerator

· Set your refrigerator or freezer temperature in average. Never adjust into extreme low or freeze that influence the energy consumption

Tips to save electricity iron

· Choose the electricity iron that use automatic thermostat

· When ironing, set the necessary level of heating that suitable with clothes type

· Avoid plug and unplug electricity from the power

· Clean the bottom of the iron from crust that prevent heating perfectly.

· Turning off the electricity iron immediately after used or in case of using another electricity appliances

Tips to save Tape Recorder, Radio and Television

· Turn off the television, radio and tape recorder and audio equipment and other visual if it is not used.

· Make sure that television, radio and tape recorder are really switch off from the main / electricity plug, not from sleep timer. For the use of sleep timer does not cut off the flow of electricity.

Tips to save water pump

· Use water tank and turn on only when the water pump is almost empty

· It will be better when using the automatic control system that terminate electricity when it is not in used, because the more often you use the water pump, the more power/energy will be consumed

Perforce energy movement must be realized in all aspects of society. It is because of the price of fuel oil potentially tend to increase that caused money spend for daily need is getting bigger too. Therefore, the use of coal is now encouraged. It is important, that the negative effects that energy use should be as minimal as possible so that the savings goal is reached.

Actually energy savings will only be successful if the management of urban areas are designed energy as efficient city. Management of energy by itself will effect to the culture of energy efficient practices.

Some experts say that some developed countries, efforts to save energy since already beginning to design the system of regulation. At least there are three important issues to be considered to build city of energy saving.

In the mechanism to build energy saving city, the transportation planning and traffic management should manage and provide with infrastructure facilities such as representative public transportation. The large scale of a city, can be also increased the number of people moving in the city each time. Therefore, planning and management of the public transport system should be efficient and representative as well. The use of private cars can be reduced since public transportation is efficient and representative.

The citizen or people can only spent only 10 percent of their annual income for transportation spending. Compare with the, the previous 15 percent, is now estimated to reach 20 percent. Socializing the use of is also able to reduce fuel consumption, beside it can make people healthy, it also minimize the living cost. Brazil of the model city that apply this methods that make this city has lowest levels of pollution in the world.

Source:
suarapembaruan online